-
Parts Desk 1.14.0 Stable
released this
2026-10-03 20:41:03 +02:00 | 32 commits to main since this releaseDiagrams that check your wiring and write your pin setup.
- Wiring checks: the editor looks for mistakes while you draw and marks them on the wire or component (red = error, orange = warning, blue = tip):
- short circuits (GND wired to power)
- 5 V wired to 3.3 V pins
- TX to TX or RX to RX (they should cross over)
- SDA and SCL mixed up, MOSI to MISO
- ESP32 / ESP8266 flash pins, ESP32 input-only pins (34-39) driving something, GPIO12 at boot, other boot (strapping) pins
- modules with signal wires but no GND or power
The toolbar shows how many problems there are; click it for the list, and click a problem to jump to it
- Net labels (+ Label): GND, 3V3, 5V, SDA... Labels with the same name are connected, so power and ground don't need long wires. Clicking a wire or label lights up everything on that net
- Wiring & code...:
- the wiring as a table (copy as Markdown, or save as CSV for Excel)
- pin definitions for Arduino (
#define GC9A01_CS 1), ESPHome (substitutions) and MicroPython, using the board's real GPIO numbers (D21 = 21, TX2 (17) = 17, NodeMCU D2 = 4, Arduino A0 stays A0) - the parts list, with stock, and Add to the project's parts to put it on the project (raising quantities where the diagram uses more)
- Undo/redo in the editor toolbar are now compact icon buttons
Downloads
-
Source code (ZIP)
0 downloads
-
Source code (TAR.GZ)
0 downloads
- Wiring checks: the editor looks for mistakes while you draw and marks them on the wire or component (red = error, orange = warning, blue = tip):