-
Parts Desk 1.13.0 Stable
released this
2026-10-03 16:19:33 +02:00 | 33 commits to main since this releaseDiagram wires are now straight lines with square bends, instead of curves.
- Wires leave a pin straight out and turn at right angles. Wires running side by side each get their own lane (on the grid), so a bundle of wires reads as neat parallel tracks instead of a tangle
- Wires go around boards instead of disappearing underneath them
- Click a wire and drag one of its lines (the small squares) to move it; it stays square. Double-click a wire to add a bend there, then drag one half to make a step. Dragging a step back flat removes it again
- Reset route (in the wire panel) lets Parts Desk lay a wire out again
- Moving a component keeps its wires attached and square
- Prefer the old look? Tick Curved wires in the editor toolbar (per diagram)
- Existing diagrams switch to square wires automatically; nothing needs converting
Downloads
-
Source code (ZIP)
0 downloads
-
Source code (TAR.GZ)
0 downloads